The mSwitch™ Trunk Gateway lets you offer enhanced IP-based telephony services even as you migrate to a new infrastructure -without disrupting service or subscriber dialing patterns. The TG's main role is to serve as a voice/data/fax bridge between IP networks and legacy PSTN/ wireless networks. It functions seamlessly and transparently with the legacy PSTN, providing maximum scalability and cost-efficiency.
GENEW chassis XG(S)PON platform consists of OLT, ONT and ODN, represents a high-speed, fibre to the home or building or Curb (FTTH, FTTB, FTTC and etc.) alternative to Copper. For the smooth evolution from DSL to GPON/XG(S)-PON, GENEW's OLT platform supports coexistence of GPON service boards and XG(S)-PON service board. Also GENEW's OLT platform supports Combo-PON service board which included GPON+XG-PON and GPON+XGS-PON for the case of different GPON/ XG-PON/ XGS-PON service in the same ODN. Suppliers can smoothly evolve from GPON to XG(S)-PON in the same platform.
Availability: | |
---|---|
Description
The HR5241, a SHDSL (Single-pair High-bit-rate Digital Subscriber Line) Router, provides a broadband transmission with bandwidth up to 5.696Mbps (15Mbps for PAM128 ) over a single pair of copper wires for LAN connection between two local area networks. HR5241 provides a console port for users to configure the settings and to monitor the DSL connection status. HR5241 conforms to ITU-T G.991.2, the GSHDSL requirements. Each HR5241 can be configured as either STU-C for the central side or STU-R for the remote side. HR5241 offers a cost effective symmetrical broadband solution for bandwidth-hungry applications such as LAN-to-LAN connection, Internet.
Features:
ITU G.991.2 Annex A, Annex B ,Annex F, Annex G
Symmetrical downstream and upstream data rates from 192Kbps to 15Mbps
Support ATM/EFM over SHDSL
Auto or Fixed DSL rate operation
Auto-Negotiation for 10/100 Base-T
Auto-MDIX for Auto Ethernet Tx/Rx Swap
SNMP management with SNMPv1 / SNMPv2 /SNMPv3 agent and MIB II
Support 802.1q with 4094 VLAN
Support DHCP server
Support ping tool
Support Bridge, Routing and NAT via setting
Web, Telnet supported
Getting enhancements and new features via firmware upgrad
Description
The HR5241, a SHDSL (Single-pair High-bit-rate Digital Subscriber Line) Router, provides a broadband transmission with bandwidth up to 5.696Mbps (15Mbps for PAM128 ) over a single pair of copper wires for LAN connection between two local area networks. HR5241 provides a console port for users to configure the settings and to monitor the DSL connection status. HR5241 conforms to ITU-T G.991.2, the GSHDSL requirements. Each HR5241 can be configured as either STU-C for the central side or STU-R for the remote side. HR5241 offers a cost effective symmetrical broadband solution for bandwidth-hungry applications such as LAN-to-LAN connection, Internet.
Features:
ITU G.991.2 Annex A, Annex B ,Annex F, Annex G
Symmetrical downstream and upstream data rates from 192Kbps to 15Mbps
Support ATM/EFM over SHDSL
Auto or Fixed DSL rate operation
Auto-Negotiation for 10/100 Base-T
Auto-MDIX for Auto Ethernet Tx/Rx Swap
SNMP management with SNMPv1 / SNMPv2 /SNMPv3 agent and MIB II
Support 802.1q with 4094 VLAN
Support DHCP server
Support ping tool
Support Bridge, Routing and NAT via setting
Web, Telnet supported
Getting enhancements and new features via firmware upgrad
Hardware Specification
Power Supply | Adaptor 100~240V AC, 50/60Hz : plastic AC 90~260Vac(47~63Hz), DC -36 ~ -72 Vdc. AC+DC seletable: Metal |
LAN Port | RJ45 x 4 |
WAN Port | RJ45 x 1 |
Console Port | RJ45x1 |
Operating Temperature | 0° to 45°C |
Storage Temperature | -10° to 70°C |
Housing | Plastic / Metal |
Dimension | 215 mm x 120mm x 44 mm (L x W x H) : plastic ; 234.4mm x 155.5mm x44.2mm: Metal |
G.SHDSL Specification
Fully compliant with standards of ETSI (SHDSL, SHDSL.bis), ITU (G.SHDSL, G.SHDSL.bis, g.998.2/g.bond) and IEEE (EFM)
Line Code: TC-PAM 16/32/64/128
ITU G.991.2 Annex A ,B
STU-C/STU-R mode selectable
Impedance: 135 ohm
SNR /Attenuation Value calculation
Physical interfaces
4 ports RJ45 for 10/100Mbs Ethernet LAN connection
1 RJ-45 port for 1 pair G.SHDSL connection
1 console port for local configuration and management ATM Protocol
ATM adaptation
ATM adaptation layer type 5 (AAL5)
VC multiplexing and LLC encapsulation
Multi-protocol over AAL5 (RFC 1483 bridged PDU)
Support 5 PVCs
Bridging
IEEE 802.1D transparent learning bridge
Up to 1K MAC learning addresses
Routing Capability
Support IP/TCP/UDP/ARP/ICMP protocols
IP routing with static routing and RIPv1/RIPv2 (RFC1058/2453)
Configuration
Local console
Telnet access
Web-based GUI
Network Management
Web-based GUI for express setup, configuration and management
CLI interface for local console and Telnet access
Password protected management
SNMP management with SNMPv1/v2c/v3
Software upgrade via HTTP
Hardware Specification
Power Supply | Adaptor 100~240V AC, 50/60Hz : plastic AC 90~260Vac(47~63Hz), DC -36 ~ -72 Vdc. AC+DC seletable: Metal |
LAN Port | RJ45 x 4 |
WAN Port | RJ45 x 1 |
Console Port | RJ45x1 |
Operating Temperature | 0° to 45°C |
Storage Temperature | -10° to 70°C |
Housing | Plastic / Metal |
Dimension | 215 mm x 120mm x 44 mm (L x W x H) : plastic ; 234.4mm x 155.5mm x44.2mm: Metal |
G.SHDSL Specification
Fully compliant with standards of ETSI (SHDSL, SHDSL.bis), ITU (G.SHDSL, G.SHDSL.bis, g.998.2/g.bond) and IEEE (EFM)
Line Code: TC-PAM 16/32/64/128
ITU G.991.2 Annex A ,B
STU-C/STU-R mode selectable
Impedance: 135 ohm
SNR /Attenuation Value calculation
Physical interfaces
4 ports RJ45 for 10/100Mbs Ethernet LAN connection
1 RJ-45 port for 1 pair G.SHDSL connection
1 console port for local configuration and management ATM Protocol
ATM adaptation
ATM adaptation layer type 5 (AAL5)
VC multiplexing and LLC encapsulation
Multi-protocol over AAL5 (RFC 1483 bridged PDU)
Support 5 PVCs
Bridging
IEEE 802.1D transparent learning bridge
Up to 1K MAC learning addresses
Routing Capability
Support IP/TCP/UDP/ARP/ICMP protocols
IP routing with static routing and RIPv1/RIPv2 (RFC1058/2453)
Configuration
Local console
Telnet access
Web-based GUI
Network Management
Web-based GUI for express setup, configuration and management
CLI interface for local console and Telnet access
Password protected management
SNMP management with SNMPv1/v2c/v3
Software upgrade via HTTP